Description
Technical data
| Brand | Victron Energy |
|---|---|
| Model | Orion XS 12/12-50A |
| Order code | ORI121217050 |
| Device type | DC-DC battery charger and power supply |
| Input voltage range | 9 to 17 V |
| Output voltage adjust range | 10 to 17 V |
| Output voltage tolerance | ± 0.25 % (max) |
| Output voltage noise | 10 mV rms |
| Input and output current setting range | 1 to 50 A, 0.1 A step |
| Maximum constant short-circuit current | 50 A |
| Continuous output power up to 40 °C (1) | 700 W (4) |
| Maximum efficiency | 98.5 % |
| No-load current consumption | < 100 mA |
| Standby current consumption | < 1.5 mA |
| Use as power supply | yes, output voltage can be set with the VictronConnect App |
| Charge algorithm | adaptive four-stage, fully programmable, eight pre-programmed battery settings |
| Smart alternator | engine shutdown detection, the charger is active only when the alternator supplies power |
| Protections | overload, short circuit, excessive temperature (output power reduction); low temperature shutdown; configurable input undervoltage lockout with restart |
| Remote on/off | remote on/off connector or the VictronConnect App (e.g. a switch or a BMS) |
| Parallel operation | yes, unlimited number of units |
| VictronConnect App / Bluetooth Smart | yes (Instant Readout) |
|---|---|
| VE.Smart Networking | yes (2): receives Vsense, Tsense and Isense from a BMV, SmartShunt or Smart Battery Sense; synchronised charging is not supported |
| VE.Direct | yes, including DVCC (3) |
| DVCC requirement | Orion XS firmware v1.03 or later and Venus OS v3.20 or later on the GX device |
| GX device compatibility | GX devices (e.g. Cerbo GX, Ekrano GX) via VE.Direct; monitoring via the VRM Portal and Remote Console |
| Operating temperature range | -20 to +60 °C (derating 1.5 % per °C above 40 °C) |
| Humidity | 95 %, non-condensing |
| Maximum altitude | 2000 m |
| Pollution degree | PD2 |
| Overvoltage category | OVC 1 |
| DC connection | screw terminals |
| Maximum cable cross-section | 4 AWG |
| Weight | 0.330 kg |
| Dimensions (h × w × d) | 137.3 × 123.1 × 40 mm |
| Protection category | IP65 |
| Standards – safety | IEC 62477-1 |
| Standards – EMC | EN 300 328, EN 301 489-1, EN 301 489-17, FCC 15B, ICES-003 |
| Standards – automotive directive | ECE R10-6 |
| Note on power (4) | 700 W is the nominal power at a typical voltage of 14 V; power is voltage times current (12 V × 50 A = 600 W, 14 V × 50 A = 700 W) |
What the Orion XS 12/12-50A does
The Orion XS is an adaptive DC-DC charger for dual-battery systems charged by an (intelligent) alternator. The 12/12-50A takes 9 to 17 V at the input and charges the service battery with an output voltage adjustable from 10 to 17 V and a current from 1 to 50 A. It works both as a battery charger and as a power supply.
The manufacturer highlights cases where a Euro 5 or Euro 6 smart alternator supplies too low a charging voltage even with the engine running, or where long cables in boats and RVs cause voltage drops. The Orion XS then charges the service battery in a controlled way while protecting the starter battery from discharge.
Typical use
The Orion XS 12/12-50A is intended for dual-battery systems in vehicles, RVs and boats where the service battery is charged from the alternator. The input range of 9 to 17 V matches a 12 V on-board network and the 10 to 17 V output allows the voltage to be set to the chosen battery type. Because the output voltage can also be set independently of the battery type, the unit works as a regulated power supply too.
With long cable runs between the alternator and the service battery a voltage drop occurs that would prevent the battery from being fully charged. A charger with adjustable output voltage and current compensates for this, and the charge current can be limited according to the alternator and the cables used.
Several chargers can be connected in parallel if a charge current above 50 A is needed. Power at 14 V is 700 W.
Main benefits
- Current adjustable in 0.1 A steps: the charge current is set in VictronConnect in the range 1 to 50 A.
- Efficiency up to 98.5 %: low losses and little heating.
- IP65: a dust-tight housing that also withstands heavy rain.
- Adaptive four-stage algorithm: fully programmable, with eight pre-programmed battery settings.
- VE.Smart Networking and VE.Direct: wireless and wired connection to battery monitors and a GX device.
- Weight 0.33 kg: dimensions 137.3 × 123.1 × 40 mm.
Charge algorithm and batteries
The algorithm is an adaptive four-stage one. With lead-acid batteries the absorption time after a shallow discharge is kept short to avoid overcharging, and after a deep discharge it is automatically extended so that the battery is fully recharged. The Orion XS includes fully programmable algorithms and eight pre-programmed battery settings.
To prevent damage to lithium batteries the charger switches off automatically at low temperatures. It also shuts down when the input voltage drops below a configurable lockout value and restarts when it rises above the restart value; this protects the input source, for example the starter battery, from deep discharge. Always check the choice of battery and the charge parameters with the battery manufacturer.
Smart alternator and control
A built-in mechanism detects whether the engine is running (engine shutdown detection) and activates the charger only when the alternator supplies power. The charger therefore draws energy only while the engine is running.
The Orion XS can be switched on and off remotely via the remote on/off connector or in VictronConnect. Typically a switch or a battery management system (BMS) is wired in.
Integration with a GX device
Through the VE.Direct port the Orion XS is connected by cable to a GX device such as the Cerbo GX or Ekrano GX, to a PC or to other devices. This enables advanced monitoring, control and diagnostics from anywhere (requires a GX device connected to the internet and the VRM Portal) or locally via the Remote Console. DVCC is also supported, i.e. Vsense, Tsense, Isense, a system-wide charge current limit and BMS control. DVCC requires Orion XS firmware v1.03 or later and Venus OS v3.20 or later on the GX device.
Through VE.Smart Networking the Orion XS wirelessly receives Vsense, Tsense and Isense data, for example from a BMV, SmartShunt or Smart Battery Sense, and adjusts its charge parameters accordingly. Synchronised charging is not supported.
Protection and loading
Protections include overload, short circuit and excessive temperature. When the maximum product temperature is reached the charger reduces its output power. The operating range is -20 to +60 °C, and above 40 °C the power drops by 1.5 % per °C. With limited cooling, for example insufficient airflow, the charge current is reduced sooner.
Continuous output power up to 40 °C is 700 W at a typical voltage of 14 V; at 12 V and 50 A it is 600 W. The maximum constant short-circuit current is 50 A. No-load current consumption is below 100 mA and standby consumption below 1.5 mA.
Installation in general
Cables are connected with screw terminals, the maximum cross-section being 4 AWG. The unit is mounted as described in the manual with enough free space for cooling, because cooling determines when derating starts. IP65 allows installation where there is dust or rain; maximum altitude is 2000 m and humidity 95 % non-condensing.
Dimensions are 137.3 × 123.1 × 40 mm (h × w × d), weight 0.330 kg. Wiring is for a qualified electrician; cables and fuses are sized for a current of up to 50 A.
Operation, VictronConnect and VRM
In VictronConnect you set the charge current, output voltage, algorithm, input protection values and remote control, and update the software. Instant Readout shows key data including warnings and alarms on the device list without connecting.
When connected to a GX device, the data appear on the Remote Console and in the VRM portal. Several chargers can be paralleled, and their output currents add up. The Orion XS 12/12-70A of the same range is IP20 and belongs in a dry indoor environment only; this model is IP65.
AI search description
The Victron Orion XS 12/12-50A, order code ORI121217050, is a DC-DC battery charger and power supply for dual-battery systems with a smart alternator. Input 9 to 17 V, output 10 to 17 V, current adjustable 1 to 50 A in 0.1 A steps, 700 W at 14 V, efficiency 98.5 %. Adaptive four-stage algorithm, Bluetooth, VE.Smart Networking, VE.Direct with DVCC for GX devices (Cerbo GX, Ekrano GX), parallel operation. IP65, 137.3 × 123.1 × 40 mm, 0.33 kg.
Product page: https://batterado.com/product/victron-orion-xs-12-12-50a/














Reviews
There are no reviews yet.